Plastic film is sold in several units. A South African supplier might say 50 micron, an older price list says 200 gauge, and an overseas spec sheet says 2 mil. They describe the same thickness, and the thicker it is the more film you pay for. This converter shows all four units at once, then uses the density of the plastic to work out the film weight in grams per square metre, the square metres in a kilogram, and the weight and cost of a flat bag.
Micron, gauge, mil and mm: how they relate
A micron (µm) is a thousandth of a millimetre, so 50 micron is 0.05 mm. A mil, or thou, is a thousandth of an inch and equals 25.4 micron. Gauge is the older film trade unit where 100 gauge equals 25.4 micron, which makes 1 gauge 0.254 micron. A bag sold as 200 gauge is therefore about 50 micron and about 2 mil. Convert before you compare quotes, because 50 micron and 200 gauge are the same film but look very different on a price list.
To get the film weight, multiply the thickness in micron by the density in g/cm³. LDPE at 50 micron is 50 x 0.92 = 46 g/m², so a kilogram covers about 21.7 m². The same thickness in PET is about a third heavier at 69.5 g/m², which is why thickness alone does not tell you the weight.
Typical thicknesses by product
- Cling film: about 8 to 15 micron.
- Bread and produce bags: about 15 to 30 micron.
- Refuse bags: about 20 micron for light kitchen bags up to 60 micron or more for heavy duty.
- Pallet wrap: hand film usually 17 to 23 micron, and machine film often 12 to 17 micron when it is pre-stretched. See the pallet wrap guide.
- Shrink film: polyolefin shrink is often 15 to 25 micron, and heavier polyethylene shrink 40 micron or more for bundles. See shrink wrap.
- Heavy duty and industrial bags: about 50 to 150 micron for liners, ice bags and parts bags.
These are guides, and suppliers differ. Always ask for the nominal thickness and the tolerance, which is commonly plus or minus 10% or more.
Thinner film can be stronger
Strength depends on the resin, the way the film is made and how it is used as much as on the thickness. Modern linear low density polyethylene (LLDPE) and multilayer films resist tearing and puncture far better than basic LDPE at the same thickness, so a 17 micron stretch film from a good line can outperform a thicker, poorer one. Pre-stretched film is thin but strong along the wrap. Moving from 25 micron to 20 micron saves a fifth of the film, but only if the load stays tight, so run a trial on real pallets. Compare puncture, tear and elongation figures on the data sheet, not just the micron. The plastic packaging guide covers the main film types.
Buying film by the kilogram or by the metre, and carrier bag rules
Film and bags are normally priced per kilogram, while rolls of wrap and tape are priced per roll or per metre. Per kilogram favours thinner film: a thinner bag weighs less, so it costs less even at the same price per kilogram. Per metre or per bag is better for comparing finished goods, because it already includes the thickness and size. Always convert both quotes to cost per bag or per square metre before deciding.
Plastic carrier bags are regulated in South Africa. They have historically had to be thicker than a minimum, often quoted as 24 micron for carrier bags, and they carry a bag levy. The detail has changed over the years and may differ by bag type, so check the current regulations and ask your supplier to confirm the thickness and any recycled content before you order.
Frequently asked questions
How many micron is 200 gauge?
How do I convert mil to micron?
Why do two bags of the same micron weigh differently?
Is a thicker bag always stronger?
More packaging tools
- Volumetric weightCourier volumetric and chargeable weight for one parcel or a whole shipmentTL-01
- Carton size and boardCarton volume, outside size, blank size, board area and weight for a slotted boxTL-02
- Cartons per palletCartons per layer and per pallet, load height, weight and pallets per containerTL-03
- Pallet wrap filmStretch film per pallet in metres, grams and rand, with rolls needed per monthTL-04
- Packaging tapeTape per box, boxes per roll, rolls per month and tape cost for I, L and H sealsTL-05
- Bubble wrapSheet size, metres off the roll, rolls needed and bubble wrap cost per itemTL-06
- Moving boxesHow many small, medium, large and wardrobe boxes, tape and paper for your moveTL-07
- Compare supplier quotesPut up to three quotes side by side: landed cost per unit, VAT and break-even quantityTL-08
- Corrugated board guideFlute chart, box styles and a selector that suggests the right board for your loadTL-10
- Plastic recycling codesWhat resin codes 1 to 7 mean: uses, heat, food contact and recycling in South AfricaTL-11
